Electronics Forum | Wed Sep 25 11:11:14 EDT 2002 | xrayhipp
Try .005 or even .004 thick laser cut electopolish stencil and reduce grain size of paste. Go with 400 or 25 in the case of AIM. We had a similar prob.
Electronics Forum | Thu Sep 12 01:49:28 EDT 2002 | ck
Hi all, Any stencil opening recommendation for 20mils pitch mirco BGA. Currently, using 12mils round opening, 5 mils thickness. Seen to have weak joints as it crack after Ict testing. thks
Electronics Forum | Sun Oct 06 22:23:05 EDT 2002 | CH
Hi Eric, How to access to the Compaq Houston reprot. regds
Electronics Forum | Mon Oct 07 09:06:20 EDT 2002 | davef
Look here: http://www.smta.org/knowledge/proceedings_abstract.cfm?PROCEEDING_ID=898
Electronics Forum | Thu Sep 12 09:12:22 EDT 2002 | mhoughton
I have printed and placed similar devices in high volume with exactly this spec for a couple of years with no problems, are you using laser cut stencils and what type of solder paste are you using? and what is the end use of the product as it may nee
Electronics Forum | Thu Sep 12 09:15:29 EDT 2002 | mhoughton
I have printed and placed similar devices in high volume with exactly this spec for a couple of years with no problems, are you using laser cut stencils and what type of solder paste are you using? and what is the end use of the product as it may nee
Electronics Forum | Wed Oct 02 15:08:37 EDT 2002 | Eric
See Fiske first line. I'd bet You are bending or catching the assembly in the ICT. How many probes at 8OZ each? do you use on that ICT? 800 probes = 400lbs. See "Flexure induced failure of BGA solder joints" by Compaq Houston TX
Electronics Forum | Thu Sep 12 11:26:11 EDT 2002 | scottefiske
CK, If joints have been validated prior to ICT (under BGA Scope), more often than not repeatable joint fractures are due to undo stress being placed on the component during ICT test. Verify ICT probes and fixture. If after proving out fixture/pin com
Electronics Forum | Thu Sep 12 10:45:29 EDT 2002 | pbarton
We have used a laser cut stencil 0.15mm (0.006") thick with 0.3mm (0.012") square apertures radiused in the corners 0.06mm (0.0025") to aid paste release. This approach with the (type 3) paste we use has proven successful on thousands of devices plac
Electronics Forum | Fri Aug 06 03:51:06 EDT 1999 | Thomas
Could someone give recommendation on the stencil opening for printing epoxy on HAL FR4 PCB for 0805 and 0603 size chips capacitors and resisitors. My regular stencil manufacturer recommend the following: Thickness: 8 mils 0805 opening: Oblong 0.35 X
